Heat Resistant Pulse Jet Industrial Dust Collector With Filter Bag Protection System

Heat Resistant Pulse Jet Dust Collector Dust With Filter Bag Protection System:

     Dust Collector is one system to filter the dust in Fume / gas. It is mainly used for purifying the dusty gas and recycling materials

Air pulse jet bag filter housing belongs to outdoor-type, and it is composed by enclosure, chamber, ash hopper, discharge system, injection system and automation control system. It has a variety of different specifications according to different combinations of the air filter chamber and indoor air filter bag. The amount of the bags has four series: 32, 64, 96 and 128, and a total of 33 full range specifications; The parameter of the filter bag is 130 mm in diameter and 2500 mm in length; This series of dust collector for negative pressure operation, dust collecting efficiency can reach more than 99.9%, after purification the dust emission concentration of the gas is 10-50 mg/Nm³.

Dust Collector Application:

Cement production
Powder processing
Steel melting
Material handling
Primary metals, including steel-making
Metals fabrication: grinding, sawing, sanding, polishing
Paper making
Mixing and blending options
Mining
Foundries
Glass Plants
Battery Plants
 

Features of Dust Collector:

1. High efficiency≥99.5%

2. Low emission concentration ≤20um, but also ≤10um is possible after filtering according to practical situation

3. Low leakage rate

4. Material—carbon steel or stainless steel.

5. Simple Structure, easy maintenance

6. Suitable bags and bag cages fitted according to dust properties. Glass Fiber, needle felt, PTFE, p84., etc

7. The overhaul and bag replacement can be carried out for separate chamber under the condition that system blower and system run normally.

8. The whole set of equipment is controlled by PLC to realize automatic dust cleaning, dust removal, automatic temperature control and over temperature alarm

9. It is not sensitive to the characteristics of the dust, and it is not affected by dust and resistance.

     Dust collector let the air go inside through the air inlet to the dust hopper or through the open flange port to the filter bag room. The filtering bag will filter the dust, and the clean air will enter the clean air room through the filtering bag. And then the clean air will be sucked out by the draft fan. The dust will fall onto the surface of the filtering bag, and the resistance of the filtering bag in the dust collector will continue to rise, so we need to regularly remove the dust on the filter bag and clean the dust. At the same time, the PLC periodically starts the pulse valve to spray out the high pressure air into the filtering bag which can shake off the dust.